Warner Tool Company - Rifle Hardware

Rifle Hardware Warner Tool Company makes a variety of Bases, Scope rails, cheekpiece and buttplate hardware. If you have any questions, please contact us. Please note that all sight bases are made to accept the Warner receiver sight. Prices reflect a 3% cash discount.
	Made of anodized 7075 Aluminum, the Quadlock iron sight base utilizes the existing dovetail. Thus it can be moved for and aft for optimum eye relief. Top mount bases are also available for Barnard, Nesika, Quadlite, & most other round actions Quadlock: $90.00 Standard top mount: $80.00
	The "WTC Standard Base" is designed for the standard 1.350 diameter actions such as the Remington and the Winchester. It is available in different heights. WTC makes them in two sizes .650 & .675. Follow this link to calculate your base height. Please contact us if you are unsure of the height you need and we will be glad to assist you. $75.00
	The WTC Weaver style scope rail, shown here on a Nesika Bay action, has 24 minutes of taper for long range shooting. Each one is custom made and is available for most actions. It is also available in Picatinny slot spacing. Weaver: $120 Picatinny: $135
	The WTC iron sight / scope rail combo is becoming a very popular item. This incorporates a top mount base and the above mentioned scope rail. No more will you have to remove that iron base to shoot scope. This is not available for all actions, so please call for details.
	The WTC Remington style recoil lug is hardened and ground flat. The 1.0625 through diameter is bored and honed to finish. $75.00
	The WTC cheek piece hardware assembly is made of 7075 aluminum and can be used in most stocks. Having more than an inch of vertical, and three eighths of an inch of lateral movement, an uncomfortable facial position is a thing of the past. It allows the cheek piece to be removed without unscrewing the adjustment. $135.00
	While we've been making these for some time now, we thought we should makea note of our custom muzzlebrakes here. We utilize a large 3/4-24 thread for strength and ease of installation. The through hole is cut .020 over the bullet size for peak performance. The internal thread, through hole and O.D. are turned all at once to garauntee that it is in line with the bore. $165.00 Installation subject to quote.
	The WTC M-16 style extractor for your .223 solves the headache of the poor performing factory replacement extractor and the sometimes dangerous Sako style extractor. This extractor cannot be blown out. The void left by the factory extractor is filled with a steel ring; silver soldered in. Available for your .308 sizes as well.